Practice has proved that strengthening daily maintenance is the most economical and effective method. Because the flight crew is in a static state, the crew's own materials will undergo complex chemical and physical changes with oil, cooling water, diesel, air, etc., thus stopping the unit. Bad".

Diesel generator sets are the providers of emergency backup power after mains failures. Most of the time, the generators are in stand-by standby mode. Once the power is cut off, the generators are required to “start in an emergency and supply power in an emergency,” otherwise the standby units will lose meaning. How can we achieve this goal? Practice has proved that: strengthening daily maintenance is the most economical and effective method, because the flight crew is in a static state, and various materials of the unit itself will undergo complicated chemical and physical changes with oil, cooling water, diesel, air, etc. , which will "stop the bad" unit.

1, the unit start battery failure

The battery is unmaintained for a long time, and the electrolyte is not replenished in time after the water evaporates. The battery charger is not configured. The battery is discharged after a long period of natural discharge, or the charger used needs to be periodically charged and floated. Due to the negligence of the switching operation, the battery power can not meet the requirements. In addition to configuring a high-quality charger, the necessary inspection and maintenance are necessary to solve this problem.

2. Water enters the diesel engine

As the condensation of water vapor in the air occurs, water droplets are attached to the inner wall of the fuel tank and flow into the diesel. As a result, the moisture content of the diesel exceeds the limit. This diesel enters the engine's high-pressure pump, which can rust the precision coupling parts. Plunger, serious damage to the unit, regular maintenance can be avoided effectively.

3, the maintenance period of oil (two years)

The oil of the engine is a mechanical lubrication, and the oil also has a certain retention period. For long periods of storage, the physical and chemical properties of the oil will change, causing the lubrication condition of the unit to deteriorate during operation, and the damage of the unit parts will be easily caused. Therefore, the lubricating oil should be replaced regularly.

4. Replacement cycle of three filters (oil filter, machine filter, air filter, water filter)

The filter acts as a filter for diesel oil, oil, or water to prevent impurities from entering the body. In the diesel oil, impurities and impurities are also unavoidable, so the filter plays an important role in the operation of the unit, but At the same time, these oils or impurities are also deposited on the filter wall, which causes the filter capacity of the filter to decline, too much deposition, and the oil path will not be able to open. This will cause the oil machine to run with shocks due to the lack of supply of oil. Oxygen), so in the normal use of the generator set, we recommend that: First, the common unit replaces the three filters every 500 hours; second, the replacement unit replaces the three filters every two years;

5, cooling system

Pumps, water tanks and water pipes have not been cleaned for a long time, so that the water circulation is not smooth, the cooling effect is reduced, the water pipe joints are good, water tanks, waterways are leaking, etc. If the cooling system is faulty, the consequences are: First, cooling If the effect is not good and the water temperature inside the unit is too high, the Weixin unit is the most common. Secondly, the water tank leaks and the water level in the tank drops. The unit will also fail to work properly. (To prevent the freezing of the water pipe when the generator is used in winter We recommend installing a water heater in the cooling system.

6, lubrication system, seals

Due to the chemical properties of the lubricating oil or oil ester and the iron scrap generated after mechanical wear, these not only reduce its lubricating effect, but also accelerate the damage of the parts. At the same time, due to the certain corrosion effect of the lubricating oil on the rubber seal ring, the other oil seal It is also aging at any time so that its sealing effect is reduced.

7, fuel, gas distribution system

The output of the engine power is mainly that the fuel burns in the cylinder to do work and the fuel is ejected through the nozzle. This causes the burned carbon deposits to be deposited on the nozzle. With the increase of the deposition amount, the fuel injection amount of the nozzle will be affected. Impact, lead to inaccurate timing of injector ignition advance, engine cylinder fuel injection is uneven, the working status is not stable, so the regular cleaning of the fuel system, the replacement of the filter parts of its oil supply, matching The adjustment of the gas system makes it uniform.

8, the control unit of the unit

The control part of the oil machine is also an important part of the maintenance of the unit. The unit is used too long, the line connector is loose, and the AVR module is working properly.

Related Products

10 KVA LAIDONG Diesel Generator

Hot Rolling Mill

450 KVA DOOSAN Diesel Generator

Topless Tower Crane 65M 2.0-12T

400 KVA MAN Diesel Generator

Triple-bin Tube Mill Machine